One of the methods adopted for the characterization of the composite semirigid joints is the method of the components described in Eurocode 3 and Eurocode 4. The model developed in the method considered for the composite contribution the incorporation of reinforcement bar components, aspects related to the concrete and the connector strength. However, the model is based on not fully validated assumptions as to structural response of the composite portion of the joint, mainly negative moment areas. All this aspect has limited the use of the method for the design of composite structures. This fact encouraged to the conception and development of an experimental program to investigate joints in composite structures, by means of pull out tests, considering the failure modes due to rupture of the reinforcement bar, of the anchorage of the bar, and of the weld connectors. Additionally was made a research of the weld connectors influence due to failure of this element in the course of a few pull out tests. The results of the tests developed have allowed general conclusions could be determined and made possible a better understanding of the weld and its impacts to the system. The correct use of composite joints solutions can increase the competitiveness of the structural system, providing more economical and efficient buildings