The increase in photovoltaic generation has caused changes in the power system s operative and dynamic characteristics when subjected to severe disturbances. One of the most relevant problems associated with this renewable energy source is the transient stability, as renewable generation connected to the system by electronic converters does not contrinute to the increase of the total inertia of the system. However, electronic converters can potentially bring new opportunities for rapid control to support synchronous generators in response to severe disturbance. The present work proposes a control strategy for photovoltaic inverters based on the injection of the current with a major impact on the transient response of the synchronous machine rotor angle, identified through the eigenvalue sensitivity analysis and the participation factors. By doing so, it is possible to increase the synchronous machine active power output close to its pre-fault value, reducing the disequilibrium between mechanical and electrical torque. The proposed control strategy was experimentally tested using an inverter and a synchronous-motor machine assembly and, by simulating a hybrid system with a large photovoltaic system. The results show that the proposed control strategy not only conforms to the grid codes requirements to improve voltage stability during a severe disturbance, but is also able to maintain transient stability thus proving to be a better alternative to the FRT capability required by the grid codes.