The determination of unsaturated hydraulic parameters in laboratory tests is not always represents as observed on the field, especially because of the presence of errors caused by the scale factor. So, several field tests have been developed using suction measures with time for a determination of the unsaturated hydraulic properties. This research aims to use the field test proposed by Velloso (2000), called Monitored Infiltration Test (EIM) to determine the Soil Water Characteristic Curve. In this test the constant head is maintained, using a constant head permeameter and, at the same time, monitoring a variation of the suction caused by the infiltration front with a tensiometer. When a variation of the suction in the soil becomes constant and close to zero, then, the test reached a condition of permanent flow, being possible to finalize the procedure. In addition, the soil water characteristic curve (SWCC) and the respective Van Genuchten parameters, that describes a saturation curve versus the matric potential, are obtained mathematically by solving the inverse problem. In this context, the main objective of this research is to develop a detailed evaluation of the numerical and experimental procedures to use it in the Monitored Infiltration Test (EIM), following the guidelines and recommendations pointed out in previous studies in the area. Moreover, was sought a better understanding of EIM, and for this, comparative analyzes were performed with laboratory test results of the filter paper type. In addition, it was added the soil moisture monitoring during the EIM. Finally, was used many optimization methods for parameter estimation. The tests developed and presented in this research, were performed in five areas around the State of Rio de Janeiro.