The management and storage of mining waste present constant challenges due tothe increasing demands of the sector. Therefore, improving waste managementprocesses and optimizing the storage capacity of reservoirs are fundamental to theviability of a mineral resource exploration project. This study presents themethodology used to evaluate the desiccation process of washed bauxite tailings atMineração Rio do Norte (MRN). The implementation of two experimentalreservoirs at a pilot scale is proposed, allowing on-site monitoring and laboratorytests for the tailings desiccation behavior. The objective of the study is to assess thetailings behavior when disposed in different layer thicknesses, considering aspectssuch as weather conditions and drying time. The aim was to calibrate the fillingmodel and optimize the area of the reservoirs within MRN s tailings storage facility,thus improving the predictability of the structures end-of-life and enhancing theaccuracy of long-term mass balance. Field and laboratory studies involved thedeposition and monitoring of layers with thicknesses of 0.50 m and 0.80 m. Thisenabled the evaluation of the solids content at the end of the drying period.assessment of filling and settlement curves, measurement of the angle of repose atthe time of deposition and after the drying period, and analysis of crack morphologyand development. Based on the field and laboratory results obtained in this study,it can be concluded that the behavior of the tailings desiccation process is influencedby several factors. The permeability of the reservoir bottom and weather conditions(rainfall and evaporation rate) are identified as the most impactful to the process.No significant difference in the behavior of the waste was observed between the 0.50 cm and 0.80 cm layers.