Anchorage plates embedded in concrete are used with the purpose of allowing the fixation of elements for the introduction of concentrated loads into concrete structures, as well as to make possible the structural connections between prefabricated components. The plates are anchored in the concrete through studs welded to them. These plates are used in structures of nuclear power stations where a great number of equipments and pipings are fixed in the concrete structure. The research is of experimental nature and its objective is to investigate the reduction of the tensile strength of multiple studs group, anchorage plates located close to a free edge, and also of two adjacent plates, due to interference of failure concrete cones. The efficiency of an additional reinforcement (that transfers the load beyond the concrete cone), is also addressed. The experimental results suggest a significant reduction of the tensile strength for plates with studs group, and that the use of the additional reinforcement for anchorage plates located close to a free edge is not too efficient. The additional reinforcement presented a good efficiency when it was used in plates with studs group. The theoretical results obtained from equations developed to estimate the concrete failure load show, in a general way, a good agreement with the experimental results.