Annually, more than 100 billion cubic meters of gas are flared from upstream oil and gas facilities. This number was even higher a few years ago. In the past, the spotlight was on oil and natural gas was seen as a non-profitable source of energy. The worldwide concern over global warming spurred actions to reduce emissions of greenhouses effect gases, contributing to change the scenario above. The increased mobilization of regulators from many countries enforcing gas flaring and venting restrictions has contributed to the improvement of gas use. However, although some progress has been already achieved, the amount of wasted gas still needs to be reduced. In this context, the need to correctly quantify the volumes of gas flared is evident. Actions to reduce the flaring or venting of natural gas rely heavily on accurate measurements. This reflects on the rigorous flare measurement guidelines introduced by many countries to support flaring legislation. Although the flare gas measurement is not a new technique, it is still considered a challenging task and quite unique compared to other flow measurement applications. The unpredictable nature of the flaring, many times happening at inadequate facility, makes measuring it extremely difficult and complex. This work provides an overview of gas flaring, regulatory requirements in Brazil and worldwide and the characteristics and challenges of flare gas measurement. In addition, uncertainty studies were made over the daily volumes measured in the fiscal points of a typical installation, in order to analyze the influence of the uncertainty of flared gas measurement on the uncertainty of monthly gas production, which is the basis for calculating the government takes. The differences obtained between the gas flaring indirect measurement (bydifference method) and direct measurement (ultrasonic measurement) were also calculated, as well as the uncertainties related to the indirect measurement.