In this work a Scale Ground Simulator was developed. This is na equipment used to reproduce the base motion in a vehicle, due the Road where it is running. Using a procedure based on the Power flow, coupling the 3 main Simulator subsystems, a mathematical representation for the Simulator was obtained, from classical models mentioned in the bibliography. The scale models treatment was perfomed using the Similarity Theory, that permits the determination of non dimensional numbers relating the real system with its equivalent reduced or amplified. It was presented 3 methodologies, two of them are traditional and other one which is known as Inspection Method. These procedures were applied to 1, 2, 4, and 7 degrees of freedom vehicle models. Dimensional Analysis is also used to find scale models for the Simulator and for the complete system, i.e. the coupled set Simulator – Vehicle. Simulations were made for all situations, in real and scale models, using typical parameters found in literature or in equipment operation manuals, aiming to verify the systems performance, to determine the size reduction or amplification influence of and to validate the procedures presented.